How To Lift Motorcycle Without Jack

Let's go this straight.

You want to do some repair and maintenance work on your bike without using a jack to lift information technology off the footing.

Frankly, that'south NOT the safest way to practice information technology.

Ok, I become it. Lifting it upwardly isn't a problem for you. (Those numerous hours at the gym do pay off, eh).

But what if you need to hold the bike up steadily for a few hours? You'll need stable back up!

And then, what are the methods you can use for lifting if you don't want to utilize a jack?

Allow'due south find out.

Can I Elevator My Motorcycle by Myself?

To exist honest, I always prefer using a jack. Be it a motorbike jack, floor jack, or car jack, using it makes the job easier and safer.

Motorcycles are heavy vehicles. For example, take the Yamaha Tenere 700. That has a wet weight of 452 pounds.

The KTM 890 Run a risk has a dry weight of around 430 pounds.

Unless y'all are a veteran deadlifter with pillars instead of legs, handling heavy weights in the wrong way can cause serious injuries.

And without a jack to stabilize the bike, makeshift arrangements can exist risky. A slight mistake tin result in an out-of-residual motorcycle.

And trust me, you lot don't want a heavy cruiser to topple over you.

Too, well-nigh modern bikes don't come up with a middle stand. That makes the task even more than difficult.

Off-white plenty. But suppose you are stuck in a tough situation with no jack or stand with y'all?

Ok. You got me.

Absolutely, y'all tin lift the bike without a jack. There are simpler ways of doing it past making a DIY jack.

Quite merely, the motorcycle needs a flat and stable surface in the center that can residuum it. Placing it on an uneven surface tin crusade it to fall.

Yes, using a motorbike lift table is a cracking idea. But y'all demand to have the budget and space in your garage for it.

In most cases, the main reason for lifting the bike is to alter tires. You may need to replace the bearings and seals or change the sprockets. You will also demand to lift the bicycle to clean and lubricate the chain.

And to be honest, a repair shop will charge you less if you just bring them the tires, instead of the entire bike.

I thing is, I always adopt to loosen the axle nut when the bicycle is on the ground. That allows you to use a lot more strength than when the bicycle has been lifted up.

In case your bike is ready on a dolly, it's best to bring it to the footing before lifting.

How to Jack upwardly a Motorcycle Without a Jack

(Does that sound like an oxymoron? Never listen.)

Hither are some of the best means to lift up a wheel without a jack.

Using Stands

A peachy way to elevator up a dirt cycle or an enduro cycle is by using a static-style stand. These are cheap and stable stands that have prophylactic padding on the height. The iv-legged structure is simple with no moving parts.

All yous need to do is elevator the bike and identify the heart of the frame on the stand up. While lifting, make sure to back up the weight of the bike on your thigh. This will reduce the stress on your lower back.

For heavier models, you can use a elevator-blazon stand. These stands come with a pedal continued to a linkage. By pressing on the pedal, you can easily elevator the bike. It goes without saying, this method is easier on your back and arm muscles.

If you ain a sportbike, it will probably have swing-arm spools in the rear. These tin can be connected with a swing-arm spool stand for lifting the back of the bike off the ground.

Make certain you lot choose the correct spool based on the make and model of your bike. Since they are cheap, the spool stands are a good investment if yous're a DIYer.

Now, many owners leave problems related to the front wheel, forepart brakes, and forks to the mechanics. So, a front-wheel stand may not be necessary for all riders.

To elevator the front of the bike you can apply a forklift stand. These stands are placed under the fork legs.

Otherwise, you can also apply a head lift stand up. This stand uses a pin that fits under the steering stalk. So, make sure yous selection a stand of the right pin size.

Lifting a Motorbike Without Stands

What if you demand to do some urgent repairs and do not accept a stand?

Not to worry.

One of the easiest ways to lift a motorbike without a jack or a stand is to apply a set of stacked boards. Ideally, you will need another pair of hands to assist y'all with this.

While one person lifts the rear of the cycle, the other tin slide the boards below the engine block until the rear wheel is above the ground. To arrive safer, you can use additional necktie-downward straps to back up the front finish of the bike.

If you desire to warm your hands with a bit more action, you can make a makeshift jack with some wooden blocks and a few hours of spare time. While this isn't the best arrangement in terms of finesse, information technology'south a unproblematic and practical method to go the job done.

If you lot don't take any boards or wooden pieces around you, information technology's time to get innovative.

Note, these aren't the safest means to lift up a wheel but tin work during emergencies.

Remember: information technology'south always necessary to prioritize safety while using these methods.

Make sure yous use a difficult fifty-fifty surface like a physical flooring. If the bike has a center stand up utilize it for extra back up. At any point during lifting, if y'all feel the bike getting unsteady, lower it down.

Oft Asked Questions

How do you lift a motorcycle with a regular jack?

For lifting the motorcycle with a jack, y'all can use motorcycle stands. Or else, you can think of placing wooden blocks nether the engine to lift the rear bike.

Can I lift a motorcycle with a motorcar jack?

It's possible to elevator a motorcycle by using a machine jack. While the lifting mechanisms are different, using a motorcar jack is similar to using a floor jack.

How can I lift my motorcycle by myself?

Lifting a motorcycle on your own should exist done safely to avoid accidents. The all-time fashion to do that is by using a jack. Otherwise, you can employ a motorcycle stand up or make a DIY stand by using some wooden blocks.

Suvajit bought his first motorcycle at the age of 22 and has been in love with the road since so. Beingness a mechanical engineer, he takes a keen interest in technical details and a hands-on arroyo to repairing and maintaining motorcycles. He loves writing nigh various topics and also about his travels on ii wheels. One of his future plans is to travel across the Himalayas and Tibet on a motorcycle.

Source: https://motorbikesecure.com/how-to-lift-motorcycle-without-jack/

Share this post